Piscataqua Fish and Game Club, Inc.

Target Stands

  • 09/25/2017 6:30 PM
    Message # 5279062

    Does any one have any information on the target stands used at the gun range? I'd like to make a few for the club and was hoping someone could provide some information on dimensions, materials etc.

  • 09/26/2017 10:17 PM
    Reply # 5281454 on 5279062
    Anonymous member (Administrator)

    Thank you Bob. The frames are made of 2- 8' pieces of 2" strapping. Cut 2' of each end and place one across the top. The other is placed so the bottom edge is 32" from the top. Use 2- 1" screws at each end and that's it.



  • 09/30/2017 12:14 PM
    Reply # 5288766 on 5279062

    Thanks Jim, My grandson and I will put a few together in the near future. Do we need to make bases for them as well or are there some there already? Last time I was there it appeared there were only 2.

  • 09/30/2017 7:22 PM
    Reply # 5289218 on 5279062
    Anonymous member (Administrator)

    There should be 5 or 6 around. A couple more wouldn't hurt. They should be 3'x2'. I usually add a piece of cardboard to shim the spacer so the stands slid in easier. Thank you for helping out the range Bob. It is very much appreciated. 



  • 10/08/2017 7:50 PM
    Reply # 5302778 on 5279062

    Jim, My grandson and I made 4 target stands. There seemed to be plenty of them on the range so we left them down on the firing line. They can be put into use as needed. I also have lumber to build 2 more bases and we will get those done sometime soon. Bob

  • 10/11/2017 8:27 PM
    Reply # 5309628 on 5279062
    Anonymous member (Administrator)
    Thank you Bob and please thank your grandson for us also
© Piscataqua Fish & Game Club, Inc.
Powered by Wild Apricot Membership Software